Sink cut-outs should be a minimum of 50mm from the worktop front edge.
Aluminium foil should be applied to the edges of hob cut-outs.
There should be a minimum 200mm between hob cut-outs.
Hob cut-outs should be a minimum of 50mm from the worktop front edge.
Hob flange needs to sit on the aluminium foil around the cut-out, to avoid conducting too much heat into the wood and causing cracking.
When a worktop is to be fitted near to a Aga, Rayburn or similar allow a minimum gap of 4mm. Ideally a solid end cap return should be fixed across the end grain to stop any splits occurring.
- SlideThanks Again
Wonderful thanks again. Your customer service is excellent!
Installation went really well and we are really pleased with everything
4 men on site for 5mins just to help carry island in, then 2 guys stayed and finished. Quartz looks stunning.
Regards MarkSlideReally good
Many thanks for delivery of the Corian. All was really good. Would recommend you guys any day.
Installation went very well and the Apollo Quartz is beautiful!
The Corian is in fact excellent and everything we hoped for.
I know I had a few concerns but when you’re not a millionaire and parting with £4k up front it is a bit of a worry until you see the finished article.
If you are ever down this way please pop in and see the job for yourself.
Thanks again Laurence and I will have no hesitation in recommending you to anyone.
Ross and Cherrie.SlideA joy to deal with
Can I say that you and your company have been a joy to deal with, it hasn’t always been the case with other companies whilst we have been doing our new kitchen. It really makes a difference and the Apollo Magna looks amazing when it was installed.
Kind regards and all the best